Model Tech P-47 Thunderbolt Especificações descarregar pdf (Página 58)

Need help or have any questions? Call us at 1-714-963-0329 or send us an Email at service@globalhobby.net

❑ Test-fit the machine gun fairings to the leading edge of

each wing half. The center of each fairing should be 14" out

from the centerline of the wing.

❑ When satisfied with the fit, glue the fairings to the leading edge of the wing using a generous amount of Formula 560

Canopy Glue. Remove any excess glue using a paper towel soaked with water, and use pieces of masking tape to hold the

fairings in place until the glue completely dries.

Step 2: Installing the Nylon Antenna

❑ Using a ruler, measure back 3" behind the back of the canopy (on the centerline of the fuselage) and drill a 7/32" hole

through the top of the fuselage.

❑ Glue the nylon antenna into the hole using thick C/A.

☞

If any C/A gets onto the covering, remove it quickly

using a paper towel soaked with C/A Debonder.

Step 3: Installing the Tail Wheel Hatch Cover

❑ Slide the tail wheel hatch cover into place making sure the two preinstalled pins engage the two predrilled holes in the

plywood tail wheel bulkhead.

❑ Measure and mark the location of the hatch cover

mounting screw. The screw should be located on the

centerline of the hatch cover, 3/16" behind the front edge.

❑ While holding the hatch cover in place, drill a 5/64" hole

into the hatch cover and through the preinstalled mounting

block in the fuselage at the mark you drew.

❑ Remove the hatch cover and enlarge only the hole in the hatch cover using a 1/8" drill bit.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 67 68

Sem comentários

Model Tech P-47 Thunderbolt Especificações Página 58